MODELS KPTT780 and KPTT890
RE-ASSEMBLY TIPS
Core replacement on the Pro Line Series Toasters
is straight forward. Here are a few items to check during your re-assembly
procedures.
ALWAYS CHECK THE FOLLOWING:
1. Remove any soil or grime from the Toaster
Chassis and clean the offended surfaces with a mild soap solution. If the
rubber feet are damaged or worn, replace the entire set.
2. To insure customer safety, confirm that
you have a snug fit on your Core to Chassis Ground lead connection. A star
washer is used on this connector.
NOTE: Look at the lead orientation
carefully. During re-assembly be absolutely sure that this ground lead is
oriented correctly and not blocking the Crumb Tray Slot.
2. Check the orientation of the Toaster Core
relative to the Chassis by noting the side of the Toaster that has the Crumb
Tray as shown below.
3. After securing the new Core to the Chassis
you will next place the Stainless Steel Cover on the Chassis. Be sure that
the Tabs of the Cover slide into the slots of the Toaster Core as shown
in the photo below.
4. Make sure that the On/Off Switch and Shade
Control switches are keyed to the Control Assembly before tightening the
Screws in the front of the Toaster.
5. Secure the front (1/2") and rear
(1/4") brackets, the Lift Lever and Crumb Tray and you should be ready
for Final Inspection.
Last Updated: June 7, 2005